US Customary Reference Charts: Rebar, Steel Shapes, Drainage Coefficients and Federal Carbon Limits
US Customary lookup charts: ASTM A615 bar sizes #3 to #18, HP and W shapes with PZ sheet piles, FHWA HEC-22 Manning n values with TR-55 curve numbers, and GSA low embodied carbon limits for concrete and steel.
ASTM A615 Deformed Reinforcing Bar Sizes (#3 to #18): Diameter, Area, Weight, Area per Foot and Tension Development Length
Nominal diameters, bar areas and unit masses are the figures held in the platform's code-constants library for ASTM A615/A615M bars; weight per foot is the library mass converted from kg/m. Area per foot of width is the bar area times 12 in. divided by the spacing. The development length column is returned by the library's ACI 318-19 Table 25.4.2.3 function for the conditions listed in the notes.
Selected HP and W Shape Properties and PZ Sheet Pile Properties per Foot of Wall, with OSHA Subpart P Engineer-Design Provisions
Section properties of four rolled shapes and two hot-rolled Z sheet piles as printed in the producers' published tables (Nucor-Yamato structural shapes catalog, April 2023, and the Nucor Skyline PZ data sheet). These shapes are not part of the platform's code library: the linked temporary works calculator uses CNS 1490 H-shapes and Taiwan specifications in SI units.
US Drainage Reference Chart: FHWA HEC-22 Manning's n for Gutters and Storm Drains, and USDA TR-55 Runoff Curve Numbers
The figures are quoted from two U.S. Government publications: FHWA Hydraulic Engineering Circular No. 22, Urban Drainage Design, 4th edition (FHWA-HIF-24-006, February 2024), Tables 5.3 and 9.1, and USDA Technical Release 55, Urban Hydrology for Small Watersheds (June 1986), Tables 2-2a and 2-2c. They are not held in the platform's code library; roughness and curve number are user inputs in the online tools.
GSA Low Embodied Carbon Limits for Concrete and Steel (Interim IRA Material Requirements) with EPA Fuel and Freight Factors
Global warming potential limits quoted from the U.S. General Services Administration document Interim IRA Low Embodied Carbon Material Requirements dated May 16, 2023, together with two factors from the U.S. EPA GHG Emission Factors Hub (2025). The steel limits are the figures held in the platform's code library; the library's concrete entries differ from this GSA table, so the concrete rows below are taken directly from the GSA document.
Sources and disclaimer: figures on these charts are drawn from the platform's code-constants library, from steel producers' published section data, or from the U.S. Government publications named beside each entry (FHWA, USDA, OSHA, FEMA, EPA and GSA). Naming a publication does not imply endorsement by any agency. Consensus standards (ACI, ASTM, AASHTO, AISC) are identified by designation only and none of their text is reproduced. The charts are a design aid rather than an official document, so confirm each figure against the current source. Engineering submittals remain the responsibility of the licensed professional engineer who seals them.